No tracking number?
.jpg)
Aluminum Test Block (for Sensitivity) Cracked aluminum block compares sensitivity of different penetrants or sensitivity of new and old penetrants. The Aluminum Test Block is an aluminum test piece that measures 3" x 2" x 3/8" with a 1/8" wide with a milled notch that separates the blocks two sides to facilitate side-by-side penetrant comparison. The test block is used to check the strength of “in-use” penetrants.
.jpg)
ASTM test block is also known as MPT test bar used in Magnetic particle inspection. It has 7 numbers of artificial flaws (side-drilled holes). Easy to carry on site. Pocket friendly.
Ketos Ring The Ketos Ring is used to check overall performance of the magnetic particle examination system. The Ketos Ring is 5" in diameter and .875" thick, with a 1¼" diameter center hole. The block includes (12) thru-holes at .070" diameter and distances of .070, .140, .210, .280, .350, .420, .490, .560, .630, .700, .770, and .840" from the OD surface.
Permanent Magnet Yokes Permanent Magnet Yoke No electrical supply required. General Details: Permanent Magnet Yokes are a great convenience in Magnetic Particle Inspection, due to their complete portability, as no electricity is required. Lifting capacity at 100mm pole distance 50 Pounds (23 Kg).
MTU Test Block Used to test the sensitivity of Wet Method MPI Baths. Quick and easy verification and comparison of magnetic particlematerialsThe MTU-3 Test Block is used to check the sensitivity of magnetic-particle materials.This two-sided block has a variety of indications ranging in size from small to large.Use the MTU-3 to compare
Yoke Weight lift test block (18.1kg) AC yokes 4.5Kg with Carrying Handle. Permanent Magnet Test Weight 18Kg with Carrying Handle American Standard 22.5Kg
.jpg)
Mpi Weight Lift block (4.5kg) AC yokes 4.5Kg with Carrying Handle. Permanent Magnet Test Weight 18Kg with Carrying Handle American Standard 22.5Kg
MPT PIE GAUGE The pie gauge is a disk of highly permeable material divided into four, six, or eight sections by non-ferromagnetic material.
These solid copper rods (copper type 110) provide circular magnetization of hollow parts.
These solid copper rods (copper type 110) provide circular magnetization of hollow parts
NdeTech was established in 2012 as NDT based company. Our portfolio spans across industrial services and manufacturing sectors. NdeTech was established as an NDT& NDE Reference Standards and flawed weld specimens manufacturing company, and NDT Training Certification, Recruitment Consultant for Inspection Industries provider to cater to the requirements of various industries in India as well as abroad..
NDE TECH INDIA - Our Business Communication Center
support@ndetech.org.in 
+91-63790008932024 NDETECH All Right Reserved.
+91-6379000893
support@ndetech.org.in