No tracking number?
ASME Basic Calibration ½" Block Alloy Steel Long version
Long version for 60/70° transducers or phased array.
The additional length allows for a full skip to the
"top" notch. Used for establishment of primary reference responses
for UT examination of welds.
ASME Basic
Calibration Blocks are intended to be representative of actual components, and
therefore do not have the smooth scanning surfaces found on most
general-purpose test blocks like the IIW or DSC. Instead, our Basic Calibration
Blocks are media blasted on all surfaces to create a rough surface texture that
is more characteristic of real-world inspection conditions.
Geometry: Block contains three side-drilled holes at 1.5" deep
minimum at 3/32" diameter. Hole locations through the thickness are ¼, ½,
and ¾T. Also contains two EDM notches measuring 2%T deep x 1/4" max wide x
1.0" long min. In accordance with ASME Sec V Art. 4 Fig. T-434.2.1.
·
Dimensions: ½" thick x
6¼" wide x 5" long
·
Material: Alloy Steel.
Note: Customized Material also
available-
Copper Nickel, Titanium, Magnesium, Inconel, Hastelloy.
NdeTech was established in 2012 as NDT based company. Our portfolio spans across industrial services and manufacturing sectors. NdeTech was established as an NDT& NDE Reference Standards and flawed weld specimens manufacturing company, and NDT Training Certification, Recruitment Consultant for Inspection Industries provider to cater to the requirements of various industries in India as well as abroad..
NDE TECH INDIA - Our Business Communication Center
support@ndetech.org.in 
+91-63790008932024 NDETECH All Right Reserved.
+91-6379000893
support@ndetech.org.in
